New version of internet receiver box
Here are some screen shots of OLED screen and explanation
After power up, paratenki logo is shown for 5 seconds. Below the display there are two buttons, RESET reboots receiver processor and STATUS stops screensaver and shows current data.
Screen saver is activated after 10 minutes and blanks the screen. Push STATUS button to bring it back.
Receiver is trying to access DHCP server and obtain IP address.
IP address obtained (topmost line), receiver is reading current time from SNTP servers.
Current time is received, LAN check status is 'ok' (bottom line).
The data is received from the weather station (topmost line) and receiver has started to access ParaTenki server. Usually this screen goes away very fast and is replaced with the following:
Topmost line shows mountain name and the last time when data was received. If this time is well behind the clock – there might be problem with radio transmission.
Bottom line shows wind direction, speed, temperature and battery voltage.
LAN cable is disconnected, or router power went down or somehow else there's no network attached to the inet receiver. Please, check network connections and then switch power OFF and ON back again.